Safety Coverage Package
Point-based coverage for lift phones, fire panels, CCTV and emergency call boxes.
Quick Answer
Some sites do not need whole-building coverage; they need specific points to work reliably. Lift emergency phones, fire panels, CCTV backhaul and help points are typical examples. The design starts from the point list, not the floor area, and must be coordinated with the lift, fire and security vendors.
Best for
- Lift cars and lift emergency phones
- Fire alarm panels and security rooms
- CCTV or access-control backhaul points
- Parking help points and remote call boxes
What's included
- Compact or project-sized host
- Donor antenna and feeder
- One service antenna per critical point or zone
- Point-by-point test record
How the system is designed
- 1
List every critical point and the equipment it serves.
- 2
Confirm the donor signal and a practical cable route to each point.
- 3
Design and test each point with the equipment vendor.
- 4
Document the final test results for handover.
Boundaries and notes
- This package improves radio coverage; it is not a certified fire or life-safety system by itself.
- Acceptance must follow local codes and the requirements of the lift, fire or security equipment vendor.
- Do not modify lift control, fire alarm or security circuits without the vendor’s approval.
Recommended Signal Booster Solutions
The models below are a starting point. The final Bill of Materials is confirmed after a site survey.
HAG-05-DP Compact Dual-Band Booster
Compact 20/27 dBm dual-band booster with ALC/AGC.
AL-30 Multi-Band LCD Signal Booster
Multi-band booster with LCD display, AGC and isolation detection for 100–3,000 m² coverage.
Indoor Omnidirectional Ceiling Antenna
3 dBi omnidirectional ceiling antenna for 800–2700 MHz.
View DetailsRequest a Safety Coverage Package proposal
Share the site conditions and we will reply with a preliminary assessment and the measurements still needed.
Frequently Asked Questions
Still unsure about the site? Send what you know and we will explain what to measure next.
Start with a signal checkDoes this package certify the lift phone?
No. It improves the radio path, but the lift phone and alarm system must be tested and accepted by the lift vendor and building operator under local rules.
Can one host serve several critical points?
It can, if the host has enough output and the distribution design keeps each point within its required level. Critical points should be tested individually.
Do you coordinate with the lift or fire contractor?
We can provide the design and remote support, but the local contractor and equipment vendor must approve interfaces, installation methods and final acceptance.