Before installation
Confirm the system diagram, equipment list, antenna positions and cable routes before work starts. The site should have a usable outdoor donor and an agreed host location with power and ventilation.
- Check the donor level at the final antenna position
- Confirm antenna separation and isolation
- Verify cable routes, bend radius and weatherproofing
- Confirm power, grounding and equipment access
Installation sequence
Install the donor antenna and feeder first, then the host, then the distribution network and service antennas. Test the donor input before connecting the full distribution system.
- Mount the donor antenna with a clear direction to the serving cell
- Run the feeder with drip loops and weatherproof connectors
- Install the host in a ventilated, accessible location
- Connect splitters/couplers and service antennas per the diagram
Commissioning and acceptance
Commission one zone at a time. Check output level, isolation and signal quality at agreed test points. Record the results and note any area that still needs adjustment.
- Confirm no self-oscillation or alarm condition
- Test voice/data at each agreed point
- Record RSRP/SINR and throughput where relevant
- Hand over the final system diagram and test record
Need help with installation or commissioning?
Share the site conditions and we will reply with a preliminary assessment and the measurements still needed.
Frequently Asked Questions
Do you provide on-site installation?
No. Installation is handled by the customer or a local contractor. We provide the design, diagrams, installation notes and remote commissioning support.
What is the most common installation mistake?
Insufficient separation between donor and service antennas, causing self-oscillation or reduced gain. Always confirm isolation before increasing output.
How do we accept the system?
Agree the test points and acceptance criteria before installation, then measure RSRP/SINR and voice/data performance at each point. Record the results for handover.