Warehouse Cell Signal
Keep scanners and forklift terminals connected across the aisles.
Application Overview
Warehouse cell signal is lost among metal racking, high ceilings and concrete floors. A zoned DAS with antennas over aisles and loading docks keeps scanners and forklift terminals connected. Start with a pilot aisle and measure the result before covering the full warehouse.
Typical Installation Layout
A typical installation uses an outdoor donor antenna, a booster or fiber repeater, a distribution network and indoor service antennas.
- 1
Mount the donor antenna on the roof or a high exterior wall with a clear path to the base station.
- 2
Install the booster in a protected equipment area and run feeder cable along cable trays.
- 3
Use directional panel antennas along the main aisles and ceiling antennas in offices and dispatch areas.
Installation notes
- Keep antenna heights consistent and avoid aiming across metal racking.
- Use splitters and couplers to balance long branches.
- Protect outdoor connectors with weatherproof tape.
Recommended Signal Booster Solutions
The models below are a starting point. The final Bill of Materials is confirmed after a site survey.
HAG-08-33 Dual-Band High-Power Booster
33–43 dBm dual-band booster covering up to 30,000 m².
HAG-D5-37 Long-Range Dual-Band Booster
37–43 dBm dual-band booster covering 3,000–15,000 m².
AL-30 Multi-Band LCD Signal Booster
Multi-band booster with LCD display, AGC and isolation detection for 100–3,000 m² coverage.
Request a Solution
Share your floor plan, coverage area and target bands. Our engineering team will propose a practical configuration.
- sale@cellphonenetworkbooster.com
- Mon – Fri, 9:00 – 18:00 (GMT+8)
Helpful with your enquiry
- Floor plan or site photos
- Area, floors and ceiling height
- Target bands and operators
Frequently Asked Questions
What output power is suitable for a 10,000 m² warehouse?
A 37–43 dBm host with a distributed antenna system is a common starting point. The exact configuration depends on ceiling height, racking layout and the outdoor donor signal.
Can we use directional antennas instead of ceiling antennas?
Yes. Panel antennas along aisles often work better than ceiling antennas in high warehouses because they direct signal down the aisle.
How do we avoid interference with forklift systems?
Use the licensed operator bands only and keep the booster output within local limits. A site survey should identify any sensitive equipment before installation.
Can the system be expanded later?
Yes. Choose a host with spare capacity and leave spare ports on splitters. Additional antennas can be added as the warehouse layout changes.