Hotel Cell Signal
Guest rooms, corridors and back-of-house covered with discreet antennas.
Application Overview
Hotel cell signal must work in guest rooms, corridors, the lobby and back-of-house. A zoned DAS with discreet antennas keeps coverage even without putting visible equipment in guest areas. Coordinate antenna positions with interior design and the hotel IT team during the survey.
Typical Installation Layout
A typical installation uses an outdoor donor antenna, a booster or fiber repeater, a distribution network and indoor service antennas.
- 1
Survey the outdoor donor and identify a roof or facade position that does not affect the building appearance.
- 2
Install the host in a secure technical room and distribute signal by floor with splitters and couplers.
- 3
Cover corridors, lobbies, restaurants and back-of-house first; add guest-room antennas only after a floor test.
Installation notes
- Coordinate work with hotel operations; use low-visibility antennas and avoid guest-facing cable routes.
- Confirm whether all target operators need coverage; multi-band hosts may be required.
- For remote resorts, treat the donor side as a separate design problem and confirm the outdoor signal first.
Recommended Signal Booster Solutions
The models below are a starting point. The final Bill of Materials is confirmed after a site survey.
AL-30 Multi-Band LCD Signal Booster
Multi-band booster with LCD display, AGC and isolation detection for 100–3,000 m² coverage.
HAG-33DB3P Tri-Band Booster
Tri-band 33 dBm booster for multi-operator coverage.
Indoor Omnidirectional Ceiling Antenna
3 dBi omnidirectional ceiling antenna for 800–2700 MHz.
View DetailsRequest a Solution
Share your floor plan, coverage area and target bands. Our engineering team will propose a practical configuration.
- sale@cellphonenetworkbooster.com
- Mon – Fri, 9:00 – 18:00 (GMT+8)
Helpful with your enquiry
- Floor plan or site photos
- Area, floors and ceiling height
- Target bands and operators
Frequently Asked Questions
Do we need an antenna in every guest room?
Not always. Corridor ceiling antennas often cover standard rooms, especially when doors and partitions are not heavily shielded. In-room antennas are added where tests show weak coverage or where the room layout requires it.
Can installation be done without closing floors?
Most work can be phased by floor or by zone, with noisy work scheduled outside peak occupancy. The exact plan depends on cable routes, riser access and the hotel’s renovation schedule.
Can the system cover multiple operators?
Yes, with a multi-band host and the correct frequency configuration. Confirm the bands used by the target operators and any local approval requirements before ordering.